Guition JC1060P470 (7" ESP32-P4)
Also known as: JC1060P470 · Guition 7 inch ESP32-P4
The price disruptor of the ESP32-P4 wave: a 7" 1024x600 MIPI-DSI capacitive touch panel with Wi-Fi 6 for ~$35 — the resolution and smoothness the S3 RGB boards can't reach, at Sunton money. A 10.1" sibling (JC8012P4A1) is ~$44.
As an Amazon Associate and an affiliate we may earn from qualifying purchases. Prices and availability are set by the retailer.
At a glance
⚑ flag an error| SoC | ESP32-P4 |
|---|---|
| Vendor | Guition (Shenzhen Jingcai) |
| Type | Display board |
| Memory | 32 MB PSRAM |
| Display | 7" 1024x600 IPS (MIPI-DSI panel, MIPI-DSI bus), capacitive touch |
| Connectivity | Wi-Fi 6 (via ESP32-C6), BLE 5 |
| USB | USB-C |
| Battery | No |
| Onboard extras | sd |
| Typical price | $34-42 (street, varies) |
Compare all ESP32 display boards in one table →
Good for
Works with
Firmware and UI-stack support, with a known-good starting point where one exists. "Community" means an unofficial but working config or port.
- ESPHome In progress
- LVGL / Arduino Community support config / port →
Gotchas to know
- Bleeding-edge software: ESPHome's P4/MIPI-DSI support is new and buggy, arduino-esp32 P4 is beta — plan on ESP-IDF + LVGL (Guition ships 'Guition Designer' LVGL examples).
- The P4 has no radio; Wi-Fi 6 runs on a companion ESP32-C6 via ESP-Hosted.
- Docs are thin even by clone-vendor standards; community threads are the real manual.
- P4 silicon revision 3.0 (2026) changes power rails — early and late boards may differ.
Variants
Siblings: JC8012P4A1 (10.1" 800x1280, ~$44) and the bare JC-ESP32P4-M3 dev board (~$14). Specs are community-sourced; flash size varies by listing — verify before quoting.
The ESP32-P4 inside
This board is built on the ESP32-P4 . See the SoC page for the full peripheral, GPIO and security details.
Adding sensors?
Presence radars, climate, CO2, energy — the sensor comparison table covers what people actually wire to these boards, with ESPHome support status and clone-risk ratings per part. Radars want a hardware UART; I2C sensors chain on two pins.
Resources
Community guides usually go deeper than this page: pinout diagrams, wiring, library setup and copy-paste example code from people who build with these boards daily.